The compact air handling units with heat pump are intended for installation in technical rooms as well as outside the building.
The units are made of mineral wool insulation panels covered with Aluzinc sheet (AZ 150). The panels are attached to a steel supporting structure that ensures the rigidity of the entire unit.
The units are equipped with:
The units are configured and ready for operation immediately after connecting (Plug&Play).
The location of the heat pump condenser and evaporator on either side of the rotary heat exchanger ensures that these components complement each other in terms of heat recovery, resulting in maximum efficiency for the entire system.
Excellent heat and moisture recovery is provided by a high efficiency sorption rotary heat exchanger. The heat recovery effect is enhanced by a heat pump based on six-row heat exchangers with a developed heat transfer surface.
Smooth heat recovery capacity adjustment
The system achieves smooth heat capacity adjustment through an electronically controlled stepper motor of rotary exchanger and the applied inverter compressor with a DC motor. The heat pump system features an additional controller equipped with sensors, which fully controls the heat pump system parameters.
The compact air handling units with heat pump are equipped with multifunctional controls integrated with the unit (Plug&Play).
Controls enables remote control of the unit operation through the factory VTS visualisation or the remote HMI Advance desktop.
The heat pump control system is integrated and consistent with the control system of the entire air handling unit. All heat pump parameters are available in the AHU control interface, but for service purposes it is also possible to directly connect the operator panel to the heat pump controller.
The integrated controls in combination with the factory wiring means that VENTUS Compact units are offered in the Plug&Play standard.
Vérifiez et téléchargez les fichiers associés au produit.
Vérifiez les installations qui utilisent nos solutions.